Vision V6-215 3.5L SOHC (1995)
13.
Remove the intake plenum support bracket bolt on each side of the plenum (Figure 6).
14.
Remove the intake plenum mounting bolts then lift the plenum up and off the engine. Discard the gasket.
15.
Cover the intake manifold openings to prevent foreign material from entering the engine. Then, using shop air, clean any loose dirt and debris from
around the fuel injectors.
16.
Tag the injector electrical connectors to identify their location then disconnect the injector electrical connectors.
17.
Using the DRB III, pressurize the fuel system.
18.
Inspect the outside of the outlet fuel rail for fuel leakage and/or cracks near the # 3 and # 5 injector ports.
19.
With the ignition key in the OFF position, disconnect the battery.
Note:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory
(clock, radio settings, etc.) when you have completed the service procedure.
20.
Remove the fuel tank filler cap to release the fuel tank pressure.
WARNING:
The fuel system is under constant fuel pressure even with the engine off. Fuel pressure must be released before servicing the fuel rail.
