Vision V6-215 3.5L SOHC (1995)
b. Remove rear disc brake rotor.
3. On models with rear drum brakes, proceed as follows:
a. Remove brake flex hose bracket from support plate and wheel cylinder.
b. Remove speed sensor cable routing tube on trailing arm bracket to spindle.
4. On all models, remove bolt attaching lateral link to rear spindle assembly.
5. Remove rear strut assembly to stabilizer bar attaching link at the stabilizer bar.
6. Loosen and remove rear spindle to strut assembly pinch bolt.
7. Tap a center punch into hole on spindle until punch is jammed into hole. Do not punch a hole in the strut with center punch.
8. Using a hammer, tap on on top surface of spindle, driving it down and off the strut assembly.
9. Let rear spindle and assembled components hang from trailing arm while strut is out of vehicle.
10. Lower vehicle.
11. Remove rear upper strut mount from vehicle by accessing the upper strut mount tower and removing the three attaching nuts from trunk of vehicle.
12. Remove strut from vehicle.
13. Reverse procedure to install, noting the following:
a. Install spindle assembly onto bottom of strut assembly. Push or tap spindle assembly onto strut until notch in spindle is tightly seated against
locating tab on strut assembly.
b. Check rear toe as outlined under "Rear Wheel Alignment" in the "Wheel Alignment" unit repair section.
