Vision V6-3.5L VIN F (1997)
Park Brake Cable Routing Clips
4.
Install the 4 routing clips attaching rear park brake cable to floor pan and frame of vehicle.
Park Brake Cable Removal From Floor Pan
5.
Connect the park brake cable to the park brake cable equalizer.
NOTE: The equalizer can be moved rearward to allow connection of the rear cable to the equalizer.
6.
Lower vehicle.
7.
Install upper center console cover assembly back in vehicle.
8.
Install shift knob on floor shifter (if equipped). Shift knob is installed by pushing shift knob down shift shaft until fully bottomed. Then install
and tighten 3/32 inch allen head set screw located on drivers side of shift knob.
9.
Install hub/bearing assembly on spindle.
Hub And Bearing Retaining Nut
10.
Install the washer and retaining nut for the hub/bearing assembly. Tighten the retaining nut to a torque of 168 Nm (124 ft. lbs.).
