Vision V6-3.5L VIN F (1997)
Ignition Cable: Service and Repair
The content of this article reflects changes called for in TSB 26-12-96.
Fig 29 Spark Plug Cables
The cables insulate the spark plugs and seal the top of the spark plug tube. A grooved tray routes the cables from the coil to each cylinder. The cables
for the even number cylinders run along the bottom of the tray (Fig. 29). Cables for the odd number cylinders run along the top of the tray. Access the
cables through the openings between the runners of the intake manifold plenum.
CAUTION: When routing cables under the fuel rail on the left side of the engine during the cable removal or installation process, do not pry up on the
fuel rail because permanent damage may occur to the rail. This damage could result in a fuel leakage condition. Sufficient clearance exists between the
fuel rail and cam sensor for cable routing without moving the fuel rail.
REMOVAL
To remove the cables: lightly grasp the top of the boot with pliers. Rotate the cable slightly and pull straight up. To replace the cables. disconnect
the cable from the ignition coil. Remove the cable from the tray and route the coil end under the center of the intake manifold plenum.
Fig 30 Fuel Rail
INSTALLATION
To install the cables, run the coil end under the plenum and through the cable tray. Route the cables for the left side of the engine under the front of
the fuel rail and then down the side of the rail (Fig. 30). Connect the cable to the coil. Slide the insulator into the tubes and over the spark plug.
Ensure the insulator fully seats to the top of the park plug tube.