Vision V6-3.5L VIN F (1997)
Backup Light Bulb: Service and Repair
LH/CP
REMOVAL
1. Release trunk latch and open trunk lid.
2. Remove trunk lining from rear closure panel as necessary to gain access to tail lamp fasteners.
3. Remove nuts holding tail lamp to rear closure panel.
4. Separate tail lamp from rear closure panel.
Back-up Lamp Bulb
5. Remove socket from back-up lamp.
6. Pull bulb from socket.
INSTALLATION
1. Push bulb into socket.
2. Install socket in back-up lamp.
3. Place tail lamp in position on rear closure panel.
4. Install nuts to hold tail lamp to rear closure panel.
5. Install trunk lining.
6. Verify lamp operation.