Vision V6-3.5L VIN F (1997)
1. Using a lint free towel, wipe clean the open power steering hose ends, power steering pump and steering gear ports.
2. Install new O-rings and/or washer seals on the ends of the power steering hoses. Lubricate O-rings or washer seals using fresh clean power steering
fluid.
3. Install the power steering fluid pressure hose into the outlet fitting of the power steering pump. Do not tighten power steering pressure hose to
power steering pump fitting at this time.
4. Route the power steering pressure hose through the routing bracket on the engine assembly.
5. Install power steering pressure hose into pressure port of power steering gear. Tighten the power steering pressure hose to steering gear fitting to a
torque of 31 Nm (23 ft. lbs.).
CAUTION: Correct orientation of power steering pressure hose at power steering pump must be maintained. Be sure power steering hose is
installed in orientation clip at generator, prior to tightening tube fitting. This will maintain the required clearance between the power steering
pressure hose and the cam on the throttle body.
6. Route power steering pressure hose at power steering pump so it is not in contact with any engine or body components. Tighten the power steering
pressure hose fitting to a torque of 31 Nm (23 ft. lbs.).
7. Start engine and turn steering wheel several times from stop to stop to bleed air from fluid in system. Stop engine, check fluid level, and inspect
system for leaks.
CAUTION: Do not use automatic transmission fluid in power steering system. Only use Mopar (R), Power Steering Fluid, or equivalent.
8. If required fill the remote power steering pump fluid reservoir to the correct fluid level.
