Vision V6-3.5L VIN F (1997)
9. Install the battery tray. Install and securely tighten the 3 bolts and the nut, mounting the battery tray.
10. Install the battery.
11. Install the cover on the battery.
12. Install the positive and negative cables on the terminals of the battery.
13. Raise the vehicle to a point where the front tires are just off the ground.
14. Start the engine and let it run for a few seconds. Then turn the engine off.
15. Add power steering fluid to the reservoir as necessary to bring it up to the proper FULL level when cold. Repeat the above procedure until the fluid
level remains constant after running the engine.
16. Start the engine.
17. Slowly turn the steering wheel to the right and left, until lightly contacting the stops.
18. Turn off the engine. Check the fluid level and refill as required.
19. If the fluid is extremely foamy, allow the vehicle to stand a few minutes and repeat the above procedure.
