Vision V6-3.5L VIN F (1997)
Brake Light Switch: Adjustments
Stop Light Switch Location In Vehicle
PROCEDURE
1.
Remove stop lamp switch from its bracket by rotating it approximately 30° in a counter-clockwise direction.
2.
Disconnect wiring harness connector from stop lamp switch.
3.
Hold stop lamp switch firmly in one hand. Then using other hand, pull outward on the plunger of the stop lamp switch until it has ratcheted out to
its fully extended position.
4.
Install the stop lamp switch into the bracket using the following procedure. Depress the brake pedal as far down as possible. Then while keeping
the brake pedal depressed, install the stop lamp switch into the bracket by aligning index key on switch with slot at top of square hole in
mounting bracket. When switch is fully installed in the square hole of the bracket, rotate switch clockwise approximately 30° to lock the switch
into the bracket.
CAUTION: Do not use excessive force when pulling back on brake pedal to adjust the stop lamp switch. If to much force is used, damage to the
stop lamp switch or striker can result.
5.
Connect the wiring harness connector to the stop lamp switch.
6.
Gently pull back on brake pedal until the pedal stops moving. This will cause the switch plunger to ratchet backward to the correct position.
