Vision V6-3.5L VIN F (1997)
steering knuckle. Install screw and tighten to a torque of 7 Nm (60 inch lbs.).
8. Install the braking disk back on the hub and bearing assembly.
9. Install front brake caliper on steering knuckle. Refer to Brakes and Traction Control. Install the caliper to steering knuckle attaching bolts and
tighten them to a torque of 19 Nm (168 inch lbs.).
10. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
11. Lower vehicle to the ground.
CAUTION: When torquing hub and bearing assembly to stub shaft retaining nut, do not exceed the maximum torque of 163 Nm +/-14 Nm (120
ft. lbs. +/-10 ft. lbs.). If the maximum torque is exceeded this may result in a failure of the drive shaft.
