Vision V6-3.5L VIN F (1997)
-
Solid lateral link is to be installed on crossmember toward the front of the vehicle.
-
The adjustable lateral link is to be installed on crossmember toward the rear of the vehicle, with the adjustable link positioned toward the
spindle.
2. Install the right lateral links attaching bolt at the crossmember. Note: Right lateral link attaching bolts MUST be install, so head of bolt is facing
front of vehicle.
3. Position crossmember on frame rails and install the 4 crossmember to frame rail attaching bolts. Tighten the rear suspension crossmember
attaching bolts to a torque of 95 Nm (70 ft. lbs.).
4. Tighten the lateral links to crossmember attaching bolt to a torque of 140 Nm (105 ft. lbs.).
5. Align right lateral links with spindle and install the lateral link to spindle attaching bolt. Tighten the lateral link to spindle attaching bolt to a torque
of 140 Nm (105 ft. lbs.).
6. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
7. Lower the vehicle to the ground.
8. Check and reset rear wheel TOE to specifications if required.
