Vision V6-3.5L VIN F (1997)
7. If vehicle is equipped with antilock brakes, install the speed sensor head into the rear disc brake adapter. Tighten the speed sensor head attaching
bolt to a torque of 7 Nm (60 inch lbs.).
8. Install the rear hub and bearing assembly on the rear spindle. Install hub and bearing assembly retaining washer and nut on spindle. Tighten the hub
and bearing retaining nut to a torque of 168 Nm (124 ft. lbs.).
9. If vehicle is equipped with rear disc brakes, install rotor on hub. If vehicle is equipped with rear drum brakes, install the brake drum on hub.
10. If vehicle is equipped with rear disc brakes, install rear braking disc on hub. Carefully place rear brake caliper over rotor and install on adapter.
Tighten the caliper assembly to adapter mounting bolts to a torque of 22 Nm (192 inch lbs.). Refer to Brakes and Traction Control.
11. If vehicle is equipped with rear drum brakes install rear brake flex hose onto wheel cylinder and support plate. Tighten the brake hose tube nut to a
torque of 17 Nm (145 inch lbs.). Tighten the brake hose bracket attaching bolt to a torque of 8 Nm (75 inch lbs.).
12. If vehicle has rear drum brakes, brake system will require bleeding. Refer to Brakes and Traction Control.
13. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
14. Lower vehicle to the ground.
15. Check and reset rear wheel TOE to specifications if required.
