Aerostar 2WD V6-182 3.0L (1995)
Yes
GO to D6
No
SERVICE Memory 1 Circuit 267 (B/LG) from receiver assembly to door memory switches for opens or shorts to ground.
D6 CHECK RAP MEMORY SEAT 2 OUTPUT
-
Enter in NGS: RAP, ACTIVE COMMANDS, SEAT MEMORY and Turn MEMORY 2 ON, with MEMORY 1 remaining OFF.
Does driver's seat move to the memory 2 position?
Yes
GO to Pinpoint Test B to confirm that Transmitter 2 is stored in receiver assembly as Transmitter 2 (TIC2). GO to D7.
No
GO to D7
D7 MEMORY SEAT 2 JUMPERED OPERATION
-
Disconnect the receiver assembly.
-
Momentarily short Memory 2 Circuit 268 (BK/O) to Signal Ground (570 BK/W).
Did seat move to memory 2 position?
Yes
CALL phone number on receiver assembly for additional assistance.
No
SERVICE Memory Seat 2 Circuit 268 (BK/O) from receiver assembly to the door memory switches for opens or shorts to ground.
E: Confirm Normal Keypad Operation
E: KEYPAD ENTRY INOPERATIVE
E1 CONFIRM NORMAL KEYPAD OPERATION
-
Unlock driver's door with keypad code (Explorer only) .
-
Confirm that keypad lights and that interior lights come on with first button press.
-
Press 3/4 button within five seconds of unlocking doors with keypad code.
-
Press 7/8 and 9/10 button to lock all doors, turn off keypad lamp and turn off interior lights.
Do all functions occur as expected?
Yes
Keypad functions appear OK. CLARIFY with owner and REVIEW owner symptoms table.
No
If the keypad code did not work (or has been lost), GO to E2. If the doors do unlock, but the keypad doesn't light with any button press, GO to E4.
If interior lights do not illuminate, but keypad does light when keypad buttons are pressed, GO to Pinpoint Test C. If it appears that a certain
keypad button is not working, GO to E3.
E2 CHECK KEYPAD CODE
-
Enter in NGS: receiver assembly, PID/DATA. Select KEYCODE.
Does KEYCODE match keycode that owner has been trying to use as factory code (factory code should be printed on wallet code card
originally inserted in owner manual packet)?
Yes
GO to E3
No
EREPEAT E1 to confirm operation, and INFORM owner of correct keycode.
3 CHECK EACH KEYPAD BUTTON
-
Enter in NGS: RAP, PID/DATA. Select KEY PAD.
-
Confirm that numbers do not display when keypad buttons are not pressed.
-
Press each five keypad buttons separately. (Note that keypad number 1 and 2 are associated with same button and switch but appear on the display
as 1 , the 3/4 appear as -3, and so on.)
-
Confirm that display shows only keypad switch being pressed.
Do all keypad buttons change state independent of each other?
Yes
CALL phone number on receiver assembly for additional assistance.
No
If a keypad number remains displayed when no buttons are pressed, CHECK the keypad for a button short, or SERVICE the keypad button circuit
for a short to ground. If a keypad number does not display when it is pressed, CHECK the keypad for a button open, or SERVICE the keypad
button or keypad common circuit for an open. If more than one keypad number shows on display when only one button is pressed, CHECK the
keypad for a short between buttons, or SERVICE the keypad button circuits forircuits for a short.
E4 CHECK KEYPAD LAMP
-
Enter in NGS: RAP, ACTIVE COMMANDS, select KEYPAD BACK LIGHTING and turn it ON.
Does keypad lamp turn on?
