Aerostar 2WD V6-182 3.0L (1995)
4. Remove the cable anchor pin from the pivot hole in the control assembly ratchet plate. Guide the front parking brake cable and conduit from the
parking brake control.
5. Insert a 1/2-inch box end 12-point distributor lock bolt wrench over the front fitting of the front parking brake cable and conduit. Push the wrench
onto the rear parking brake cable retainer (2A709) in the rear frame crossmember (5035). Compress the retainer fingers and push the rear parking
brake cable retainer rearward through the hole.
6. Insert a 1/2-inch box end 12-point wrench over the rear fitting of the front parking brake cable and conduit. Push the wrench onto the rear parking
brake cable retainer fitting in the rear frame crossmember. Compress the retainer fingers and push the rear parking brake cable retainer forward
through the hole. Pull the cable ends through the rear frame crossmembers and remove the front parking brake cable and conduit.
INSTALLATION
1. Feed the front parking brake cable and conduit through the holes in both rear frame crossmembers. Push the rear parking brake cable retainers
