Aerostar 2WD V6-182 3.0L (1995)
14. Wrap engine accessory drive belt around all pulleys except generator. ROTATE belt tensioner CLOCKWISE and when belt clears, slip over
alternator pulley.
15. Torque water pump pulley bolts to 23-32 N.m (18-24 lb-ft).
16. Place radiator fan and clutch assembly in fan shroud and slide fan shroud into position. Lower edge of fan shroud should locate in clips at bottom
of radiator. Secure top of fan shroud with 2 screws and torque to 6-8 N.m (53-71 lb-in).
CAUTION: Fan clutch has LEFT-HAND threads so nut must be turned COUNTER-CLOCKWISE to install.
17. Install fan clutch on water pump hub and torque to 41-135 N.m (30-100 lb-ft) using Fan Clutch Holding Tool and Fan Clutch Nut Wrench.
18. Reinstall engine air cleaner outlet tube and tighten clamps.
19. Fill engine cooling system to specified level.
20. Reconnect ground cable at battery.
21. Start vehicle and check for leaks. Allow engine to reach operating temperature and verify no fluid leaks. Shut off engine, check and correct all
fluid levels.
