Aerostar 2WD V6-182 3.0L (1995)
Headlamp Bulb: Service and Repair
1. Remove the headlamp door (13064) attaching screws and remove the headlamp door.
2. Remove the four retaining screws. Do not disturb the headlamp adjusting screw (13032) settings.
3. Pull the headlamp (13005) forward and disconnect the wiring assembly plug from the headlamp bulb and retainer.
Headlamp Assembly
4. Unsnap bulb retaining wire and pull headlamp bulb and retainer out of headlamp.
5. NOTE: A properly aimed headlamp normally need not be reaimed after installation of this headlamp bulb (13007). A burned out headlamp bulb
should not be removed from the headlamp until just before a replacement is to be installed. Removal for an extended period of time may allow
contaminants (dust, moisture, smoke) to aflect the performance of the headlamp.
Install new headlamp bulb and retainer (13N021) into position.
6. Connect the wiring to the bulb. Place the headlamp in position and install the attaching screws.
