Aerostar 2WD V6-182 3.0L (1995)
Main Light Switch: Service and Repair
Removal and Installation
1. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module
(PCM)(12A650) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
Disconnect battery ground cable (14301).
2. Remove headlamp switch knob from shaft by inserting screwdriver into knob slot, depressing clip and sliding knob off shaft.
3. Remove three screws attaching steering column shroud (3530).
4. Pull off steering column shroud held by four clips.
5. Remove two screws located below instrument panel ash receptacle in depression.
6. Pull center finish panel loose (held by five clips) and hang down to allow access to cluster finish panel screws.
Left And Center Finish Panels
7. Remove left finish panel held by four clips.
8. Remove five cluster finish panel attaching screws.
Instrument Cluster Finish Panel
9. Remove cluster finish panel held by two clips.
10. Remove two headlamp switch (11654) mounting bracket screws.
