Aerostar 2WD V6-182 3.0L (1995)
Alignment: Service and Repair
Toe
1. Position vehicle on suitable alignment rack.
2. Start engine, turn steering wheel back and forth until centered, then turn ignition OFF to lock wheel.
3. Observe toe setting. If setting is not within specification, remove bellows seal clamp, if applicable, then free bellows from tie rod.
4. Loosen tie rod jam nuts, then adjust toe setting to specification.
5. Hold tie rod end with suitable wrench, then tighten jam nuts.
6. Reposition bellows, then install new clamp.
