Aerostar 2WD V6-182 3.0L (1995)
Distributor Cap: Service and Repair
REMOVAL
1. Loosen distributor cap hold-down screws.
2. Lift distributor cap with attached wire set straight off of distributor to prevent damage to the rotor blade and spring.
INSTALLATION
Distributor Cap Inspection
1. Inspect distributor cap for cracks, broken carbon button, carbon tracks, and terminals for dirt or corrosion.
2. Replace the distributor cap if damage is found.
3. Reinstall any ignition wires removed in their proper locations.
4. Install the distributor cap noting the square alignment locator, with attached wire set straight on the distributor. This will prevent damage to the
rotor blade and spring.
5. Tighten distributor cap hold-down screws to 2-3 Nm (18-27 in lb).