Aerostar 2WD V6-182 3.0L (1995)
Accelerator Pedal: Service and Repair
Accelerator Pedal Assembly
REMOVAL
1. Disconnect accelerator cable from accelerator pedal assembly.
2. Disconnect kickdown cable from accelerator pedal assembly, if equipped.
3. Remove bolt attaching accelerator pedal assembly to dash panel and remove accelerator pedal assembly.
INSTALLATION
1. Position accelerator pedal assembly to dash panel and install attaching bolt and J-nut. Tighten to 9-12 Nm (80-106 in lb).
2. Connect accelerator cable and kickdown cable to accelerator pedal assembly.
