Aerostar 2WD V6-182 3.0L (1995)
Fuel Injection System And Related Components
5. Aligning bolt holes, install throttle body on intake manifold. Install two stud bolts and four retaining bolts. Tighten to 25 Nm (19 lb ft) in sequence
shown.
6. Install alternator brace to throttle body and alternator bracket. Tighten nuts to 16 Nm (12 lb ft).
7. Connect PCV hose to tube underneath throttle body.
8. Connect vacuum hoses.
9. Connect electrical connections to the throttle position sensor, intake air temperature sensor, and idle air control valve.
10. Connect throttle cable to throttle body linkage.
11. Connect air cleaner duct hose to throttle body and air cleaner assembly. Tighten clamp to 4.0 Nm (36 lb in).
12. Connect negative battery cable.
13. Start engine and check for vacuum leaks. Adjust idle speed as necessary.
14. Install shield onto idle speed control solenoid. Tighten bolts to 1.4 Nm (13 lb in).
