Aerostar 2WD V6-182 3.0L (1995)
Child Seat Tether Attachment: Service and Repair
Installing Child Tether Hardware
1. Lower and remove the spare tire by following the instructions found in the owner's guide.
2. From inside the cargo area, drill a 3/8 inch (9 mm) hole through the desired dimple(s).
WARNING: THE TETHER BRACKET MUST BE BOLTED DIRECTLY TO THE FLOOR SHEET METAL. INTERIOR TRIM
MUST NOT BE TRAPPED BETWEEN THE ANCHOR BRACKET AND THE SHEET METAL. FAILURE TO PROPERLY INSTALL
THE ANCHOR BRACKET COULD RESULT IN IMPROPER ATTACHMENT PERFORMANCE IN THE EVENT OF AN
ACCIDENT.
3. An assistant will be needed underneath the vehicle to attach the tether anchor. Before installing the tether hardware read the instructions on the
package containing thread locking material, then open the capsule and apply thread locking material to all threads on the tether attachment bolt.
Install the child tether hardware as shown. It is important that the tether attachment bolt be torqued to 22-34 N.m (16-25 ft-lb).
4. For each tether kit installed, punch out the perforated area in the filler panel and pull out the perforated area of insulation in the rear carpet.
