Aerostar 2WD V6-182 3.0L (1995)
WARNING: THE TETHER BRACKET MUST BE BOLTED DIRECTLY TO THE FLOOR SHEET METAL. INTERIOR TRIM
MUST NOT BE TRAPPED BETWEEN THE ANCHOR BRACKET AND THE SHEET METAL. FAILURE TO PROPERLY INSTALL
THE ANCHOR BRACKET COULD RESULT IN IMPROPER PERFORMANCE IN THE EVENT OF AN ACCIDENT.
2. An assistant will be needed underneath the vehicle to attach the tether anchor. Before installing the tether hardware, read the instructions on the
package containing thread locking material, then open the capsule and apply thread locking material to all threads on the tether attachment bolt.
Install the child tether hardware as shown. It is important that the tether attachment bolt be torqued to 22-34 N.m (16-25 ft-lb).
WARNING
-
THE THREADED HOLE IN THE TETHER ANCHOR HAS AN 8 MM METRIC THREAD. A WRENCH WILL BE NEEDED TO
TIGHTEN THE 8 MM BOLT TO THE REQUIRED TORQUE. SOME CHILD RESTRAINTS COME WITH A NON-METRIC
BOLT WITH A DIFFERENT THREAD. DO NOT USE A NON-METRIC BOLT AS IT MAY BE IMPOSSIBLE TO SCREW IT
ALL THE WAY INTO THE HOLE, RESULTING IN INADEQUATE RETENTION OF THE CHILD RESTRAINT. USE ONLY
THE METRIC ANCHOR BOLT SUPPLIED IN THE KIT. IF YOU NEED A REPLACEMENT METRIC BOLT OR ASSISTANCE,
ANY FORD DEALER WILL BE HAPPY TO ASSIST YOU.
-
IF THE ANCHOR BOLT(S) ARE EVER REMOVED, THE HOLE(S) IN THE FLOOR MUST BE SEALED TO PREVENT THE
POSSIBILITY OF EXHAUST FUMES ENTERING THE PASSENGER COMPARTMENT.
