Aerostar 2WD V6-182 3.0L (1995)
Installation
1. Position the retractor assembly to the vehicle.
Install the retractor bolt. Using Seat Belt Bolt Bit (No.50 Torx(R)) T77L-2100-A, tighten to 30-40 N.m (22-30 lb4t).
2. Position safety belt guide to vehicle and install the bolt. Using Seat Belt Bolt Bit (No.50 Torx(R)) T77L-2100-A, tighten bolt to 30-40 N.m (22-30
lb-ft).
3. Install the front seat shoulder strap guide cover.
4. Install the belt loop.
5. Feed the floor anchor end of the front safety belt through the quarter trim panel.
6. Install the quarter trim panel. Place bezel around front safety belt retractor and tongue and snap onto quarter trim panel.
7. Position the floor anchor anti-rotation tab to the bead in the front floor pan. Install the bolt. Tighten the bolt to 30-40 N-m (22-30 lb-ft).
8. Check the restraint system for proper operation.
Rear Outboard, Second Row
SPECIAL SERVICE TOOL(S) REQUIRED
Description ...................................................................................................................................................................................................... Tool Number
Belt Bolt Bit (#50 Torx(R)) .............................................................................................................................................................................. T77L-2100-A
Removal and Installation
WARNING: WHEN REINSTALLING A REAR SEAT IN THE VEHICLE, INSTALL THE SEAT IN ITS ORIGINAL LOCATION.
IMPROPER INSTALLATION OF THE SEAT WILL PREVENT CORRECT USE OF THE SHOULDER SAFETY BELT AND COULD
INCREASE THE RISK AND/OR SEVERITY OF INJURY IN AN ACCIDENT.
1. Detach safety belt from rear seat back frame.
2. Remove seats from vehicle.
3. Remove D-ring cover and remove bolt securing D-ring.
4. Remove bezel from quarter trim panel.
5. Remove screws securing quarter trim panel. Bolt securing third row sling must be removed.
6. Move the quarter trim panel toward the center of vehicle for access to rear safety belt retractor and tongue.
7. Remove rear safety belt retractor and tongue assembly by passing through hole in quarter trim panel.
8. Remove bolt securing rear safety belt retractor and tongue. Remove rear safety belt retractor and tongue from vehicle.
For installation, follow removal procedures in reverse order. Tighten bolts to 30-40 N.m (22-30 ft-lb). Check safety belt for proper operation.
Make sure the belt is not twisted before you insert it into the detachable anchor. A twisted safety belt may cause the safety belt retractor and tongue to
not work properly. Insert the detachable anchor tongue into the detachable anchor until you hear a "snap" and feel the latch engage.
Rear Outboard, Second Row Bucket Seats and Three-Pass Bench
