Aerostar 2WD V6-182 3.0L (1995)
Door Switch: Service and Repair
Courtesy Lamp, Doorjamb
Removal
Courtesy Switch, Drivers Door
1. Unscrew the hex sleeve nut from the pillar.
2. Extract lamp switch (13713) and pull the main wiring (14401) off the lamp switch.
-
Retention of lamp switch to the main wiring is by one of three tabs positioned 120 degrees apart on the lamp switch.
-
When the lamp switch is disconnected from the main wiring, the engaged locking tab breaks off, the lamp switch must be rotated 120 degrees to
engage a new tab.
-
When all three tabs have been broken, the lamp switch must be replaced.
Installation
1. Pull the main wiring through the switch mounting hole in the pillar to interior lamp switch (13752). Connect the lamp switch to the main wiring.
2. Twist main wiring and lamp switch 4-1/2 turns counterclockwise, and push the main wiring and connector back through the mounting hole.
3. Screw the lamp switch into the pillar until seated.
4. Close and open the front door (20124) to make sure the interior lamp (13776) is operating properly.
