Aerostar 2WD V6-182 3.0L (1995)
Distributor Assembly
9. Remove the shaft assembly.
10. Remove the distributor stator assembly screw and retainer.
11. Remove the distributor stator from the top of the bowl.
INSTALLATION
1. Inspect distributor base housing and bushings for any indication of excessive heat concentration, cracks, or wear. Replace complete distributor if
damage is found.
2. Position distributor stator on the bushing of the distributor base housing and press into place.
3. Install the distributor stator assembly screws and retainer. Tighten screws to 2-4 Nm (18-35 in lb).
4. Lightly lubricate the shaft assembly with a coating of fresh motor oil or with Engine Assembly Lubricant D9AZ-19579-D or equivalent meeting
Ford specification ESR-M99C80-A.
5. Install the shaft assembly into the distributor base housing.
6. Place a 1/2-inch deep well socket over the end of the shaft assembly.
