Aerostar 2WD V6-182 3.0L (1995)
EXCESS STOCK RETURN
Excess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Procedure Bulletin 4000.
Attachment III - Technical Information
FUSED JUMPER HARNESS
AFFECTED VEHICLES:
1994-1995 AEROSTAR
SERVICE PROCEDURES
The following Service Procedure will install a fused jumper in the inertia switch electrical circuit.
1.
Install memory saver, then disconnect battery negative cable.
2.
Loosen three (3) front retaining screws from passenger side rocker panel scuff plate.
3.
Remove passenger side A-pillar trim panel.
4.
Remove passenger side kick panel.
5.
Disconnect electrical connector from inertia switch. See Figure 1.