Aerostar 2WD V6-182 3.0L (1995)
26.
Using foam tape, wrap both gray electrical connectors together. Refer to Figure 17.
27.
Using foam tape, wrap black electrical connector. See Figure 17.
28.
Using tie straps on relay harness, secure relay harness as shown in Figure 18. Make sure relay is accessible for service. See Figure 18.
29.
Trim tie straps.
30.
Install instrument panel reinforcing panel. Tighten retainers to 10-14 Nm (7-10 lb-ft).
31.
Install knee bolster.
32.
Connect battery negative cable.
33.
Start engine and verify modification as follows:
^
Turn blower motor to HIGH
^
Turn radio on
^
Check brake shift interlock system by trying to shift from Park to any other gear without depressing brake pedal
^
If any of the above components were operational before the modification and is not operational now, repeat the Service Procedure
