Aerostar 2WD V6-182 3.0L (1995)
Park/Neutral Position Switch: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect battery ground cable, then raise and support vehicle.
2. Disconnect switch electrical connector, then remove switch and O-ring using park/neutral position switch socket tool No. T74P-77247-A, or
equivalent.
3. Install new switch and O-ring. Torque switch to 89-123 in lb.
4. Connect switch electrical connector.
5. Connect battery ground cable, then check switch for proper operation.
6. When battery is disconnected and connected, some abnormal drive symptoms may occur while Powertrain Control Module (PCM) relearns its
adaptive strategy. Vehicle may need to be driven ten miles or more to relearn strategy.