Aerostar 2WD V6-182 3.0L (1995)
Removing Reverse/High Clutch Piston Or Air Testing Assembled Reverse/High Clutch
4. Apply no more than 20 psi air pressure to blow out clutch piston as shown in the Direct Clutch (reverse/high) Piston Removal Or Clutch Assembly
Air Test image, using finger to close off opposite hole.
ASSEMBLY
1. Install new seal rings on clutch piston.
2. Carefully install clutch piston into clutch body.
3. Install compression spring and spring retainer, compress springs using clutch spring compressor and install retaining ring, as shown in the Clutch
Spring And Compression Spring Retainer Replacement image.
4. Install clutch plates beginning with a steel plate, then alternate friction and steel plates.
5. Install pressure plate and secure with retaining ring.
6. Using feeler gauge, check clearance between retaining ring and pressure plate, pushing downward on plates while checking clearance.
7. If clearance is not 0.051-0.079 inch, install corrective selective retaining ring. Retaining rings are available in thicknesses of 0.0539, 0.0681,
0.0819, and 0.0961 inch.
8. Block hole with finger to prevent air leakage, then ensure piston applies when pressurized and releases when air is stopped, as shown in the Direct
Clutch (reverse/high) Piston Removal Or Clutch Assembly Air Test image.
