Aerostar 2WD V6-182 3.0L (1995)
Power Window Motor: Service and Repair
Removal
1. Disconnect the battery ground cable.
NOTE: On vehicles equipped with EEC, when the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the
EEC processor relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
2. Remove the door trim panel.
3. Disconnect power window motor wire harness connector.
4. Check inside the door to make sure electrical wires are not in line with holes to be drilled in the door inner panel. Using a 12.7mm (1/2-inch)
diameter drill bit, drill two holes in the door inner panel at the drill dimples located opposite the two unexposed motor drive retainer screws.
