Aerostar 2WD V6-182 3.0L (1995)
5. Remove the three motor mount retainer screws using two drilled holes and existing larger hole access to screw heads.
6. Push the motor toward the outside sheet metal to disengage the motor and drive from the regulator gear. After the motor and drive are disengaged,
prop the window in full up position.
7. Remove the motor and drive from inside the door.
WARNING: AEROSTAR HAS A COUNTERBALANCED SPRING. WINDOW MUST BE IN UP POSITION TO REMOVE POWER
MOTOR OR BLOCKED TO PREVENT WINDOW FROM SUDDENLY RAISING, CAUSING POSSIBLE INJURY.
Installation
1. Install a new motor and assembly. Tighten motor retaining screws to 5.6-9.6 N-m (50-84 in-lb).
2. Install two pieces for Pressure Sensitive Waterproof Tape D6AZ-19627-A or equivalent body tape 25.4mm (1 inch) square over drilled holes.
3. Connect power window motor wiring, and battery ground cable.
4. Remove glass prop and check window operation.
5. Make sure door drain holes are open.
6. Install trim panel.
