Aerostar 2WD V6-183 3.0L (1991)
5.
Install the Single Belt Service Kit (Refer to the Application Chart listed in this article). Refer to Figure 2 for accessory drive belt routing and to
Instruction Sheet # 6475C, included in each kit, for installation details.
Most of the Aerostar Single FEAD Belt Service Kits for the 3.0L and A/C contain the following components:
^
One (1) Auxiliary Heater Supply Tube Assembly
^
One (1) Crankshaft Damper Pulley
^
Four (4) Bolts - Crankshaft Damper
Pulley-To-Crankshaft Damper
^
One (1) Generator With Pulley
^
One (1) Generator Bracket
^
Two (2) Bolts - Generator With Pulley-To-Bracket
^
One (1) Stud - Generator With Pulley-To-Bracket
^
Two (2) Bolts - Generator Bracket-To-RH Cylinder
Head
^
One (1) Idler Pulley Bracket
^
One (1) Bolt - A/C Drive Belt Idler Pulley
Bracket-To-RH Cylinder Head
^
Two (2) Bolts - A/C Drive Belt Idler Pulley
Bracket-To-A/C Bracket
^
One (1) A/C Idler Pulley
^
One (1) Nut - Throttle Body Brace
^
One (1) Bolt - Oil Fill Tube-To-Throttle Body
Brace
^
One (1) Automatic Belt Tensioner
^
One (1) Power Steering Pump Bracket
