Aerostar 2WD V6-183 3.0L (1991)
Hall Effect Device
The distributor uses a Hall effect (PIP) switch assembly, causing the ignition coil to be switched OFF and ON by the TFI and Electronic Engine Control
(EEC) modules.
Rotary Vane Cup
As the window of the vane cup is between the magnet and the Hall Effect device, a magnetic field is completed.
Hall Effect Device Response To Vane
As the vane passes through this opening, the flux lines are shunted through the vane and back to the magnet and voltage is produced.
As the vane clears the opening, the window edge causes the signal to drop to zero volts.
This signals crankshaft position and desired spark advance based on engine demand and calibration.
Secondary voltage distribution is accomplished through a rotor, cap and ignition wires.
NOTE: The TFI module is remotely mounted within the engine compartment.