Aerostar 2WD V6-183 3.0L (1991)
Main Control Valve Body
1. CAUTION: Make sure all holes in gasket line up with holes in separator plate.
Make sure all check balls, retainers, springs and valves are installed properly.
2. NOTE: Petroleum jelly can be used to hold gasket in place.
Install a new valve body-to-separator plate gasket.
3. Install the separator plate using two tapered punches at locations "E" to align gasket and separator plate-to-valve body. Install three Torx head
screws to retain separator plate and gasket to valve body. Tighten screw to 6-8 Nm (53-71 lb-in).
4. Remove alignment punches.
5. NOTE: Use petroleum jelly to hold the gasket in place.
