Aerostar 2WD V6-183 3.0L (1991)
Clutch Slave Cylinder: Service and Repair
Removal and Installation
Slave Cylinder Removal
REMOVAL
Clutch Coupling Tool T88T-70522-A
1. Using coupling disconnect tool No. T88T-70522-A or equivalent, disconnect hydraulic coupling at transmission by sliding white plastic sleeve
toward clutch slave cylinder while tugging on tube.
2. Remove transmission.
3. Remove clutch housing to transmission attaching bolts, then separate clutch housing from transmission.
4. Remove slave cylinder from transmission input shaft.
INSTALLATION
1. Reverse procedure to install, noting the following:
a. Position slave cylinder over transmission input shaft with bleed screw and coupling facing left side of transmission.
b. Torque slave cylinder retaining bolts to 14-19 ft lbs.
c. Bleed system if required.