Aerostar 2WD V6-183 3.0L (1991)
Step 7).
7.
Remove moulding (208A96) from door frame and remove lower "B" pillar clip. Reinstall moulding without lower clip, Figure 1.
8.
Install flock run.
9.
Cycle glass to check for binding. If binding persists, continue to Step 10. If no binding, proceed to Step 15.
10.
Fabricate a tool from any convenient material such as aluminum, plexiglass, steel, etc., Figure 3. Quarter inch stock is recommended.
11.
Starting at the upper rear corner of the door, insert tool into the glass run assembly. Make certain the tool has bottomed out in the channel by
tapping tool handle with small hammer or mallet, Figure 2.
12.
Remove tool from the glass channel by wiggling inward (toward passenger compartment) and outward (toward exterior of vehicle) as you pull the
tool out until it releases from channel, Figure 2.
13.
Repeat steps 11 and 12, working down the glass channel until binding is eliminated.
14.
Check glass function: Cycle glass up and down several times to verify binding condition has been corrected.
15.
Reinstall door trim panel.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 94-15-12
WARRANTY STATUS:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage For 1992-94 Models, Basic Warranty Coverage For All Other Models
OPERATION DESCRIPTION
TIME
942409AT
Repair Both Doors
2.2 Hrs.
942409A
Repair One Door
1.2 Hrs.
DEALER CODING
BASIC PART NO.
CONDITION CODE
7021546
41
OASIS CODES: 102000