Aerostar 2WD Sliding Door Hold-Open Latch Wedge Striker Plate
Sliding Door Hold-Open Latch: Service and Repair
Wedge Striker Plate
Removal and Installation
CAUTION: For proper sliding door operation, it is critical that the two wedges on the front face of the sliding door fit smoothly into the two wedge
pockets located B-pillar. If any of the following adjustment are made, re-alignment of the two wedge-to-wedge pockets may be necessary.
1. Open sliding door and mark location of each wedge striker plate located on sliding door.
2. Remove the two attaching screws. Remove striker plate.
3. Reverse Steps 1 and 2 for installation.
