Aerostar 2WD V6-245 4.0L (1990)
Upper Sliding Door Roller: Service and Repair
Removal and Installation
1. Open and support the door.
2. Mark the location of the upper bracket assembly to the door.
3. Remove the two bolts attaching the bracket assembly to the door. Remove roller assembly by backing it out of the track opening at the back.
4. If a new bracket assembly is being installed, transfer the roller assembly to the bracket assembly and set at the same location on brackets.
5. Position the roller assembly into the track. Set the new bracket assembly to the location marks made in Step 2 on the door and install retaining
bolts.
6. Adjust as outlined.
