Aerostar 2WD V6-245 4.0L (1990)
2. On High Series-trimmed vehicles, it is necessary to remove the moulded upper body side door trim panels, the trim panel and the water shield. On
Low Series-trimmed vehicles, the remote control patch cover plate and access hole cover plates must be removed prior to proceeding to Step 3.
3. Using the lower access hole, disconnect the door lock cylinder rod and the remote actuator rod rear door latch from the remote control assembly
latch levers. If the vehicle is equipped with power locks, drill out actuator bracket rivet, disconnect electrical connector to actuator, and remove
remote control assembly with actuator.
4. Using a 1/4-inch diameter drill, drill out the five rivets attaching the remote control assembly to the door inner panel. Use care not to enlarge or
route out inner panel retainer holes while drilling. Remove the remote control assembly.
5. Reverse Steps 1 through 4 when installing the body side sliding door remote control assembly.
