Aerostar 2WD V6-245 4.0L (1990)
4.
Install an 8 mm bolt into the shaft hole of the hub to force the hub from the shaft, Figure 1.
Figure 2
5.
Remove the shaft seal felt from the nose of the A/C compressor using Rotunda Tool T71P-19703-C, Figure 2.
6.
Clean the seal cavity with low pressure compressed air and a lint-free cloth.
Figure 3
7.
Insert the tip of snap ring remover T89P-19623-DH into one of the eyes of the shaft seal retaining snap ring located inside the compressor nose,
Figure 3.
8.
Position the tool tip and snap ring eye as shown in Figure 3.
9.
Pull the snap ring remover up quickly while keeping the tool against the side of the compressor nose housing, Figure 3.
