Aerostar 2WD V6-245 4.0L (1990)
Fig. 18 Quick connect coupling removal & installation
4.
Remove floor duct, using quick disconnect tool, Fig. 18, disconnect and plug suction line from evaporator core.
5.
Disconnect solenoid bracket from case.
6.
Disconnect evaporator core from solenoid valve.
7.
Remove auxiliary case cover, then the resistor block connector.
8.
Remove evaporator core from vehicle.
9.
Reverse procedure to install. Use new O-ring lubricated with clean refrigerant oil.
10.
Leak test, evacuate and charge system.
