Aerostar 2WD V6-245 4.0L (1990)
of the way. Refer to the appropriate service repair manual for removal and installation procedures. Once access is gained, proceed as follows.
NOTE:
The new ignition switch is shipped in the LOCK position. Keep the ignition lock cylinder (ignition key) in the lock position during this procedure.
3.
Disconnect electrical connector from the ignition switch.
4.
Remove ignition switch retaining screws.
5.
Disengage switch from the actuator pin and remove switch from vehicle.
6.
Remove the positioning clip from the new ignition switch if so equipped, and install the switch onto the actuator pin. Align the switch mounting
holes with the column lock housing threaded holes.
7.
If supplied, install new retaining screws. If re-installing original screws, apply Ford Threadlock and Sealer E0AZ-19554-AA (CXC-70) or
equivalent to the threads. Tighten to 6-8 N-m (53-70 in-lb).
8.
Connect electrical connector to the ignition switch. Ensure that the connections are tight and fully seated.
9.
Connect battery negative cable and remove Rotunda Memory Saver.
10.
Check ignition switch for proper function, including START and ACC positions.
11.
Check the wiring in the area of the upper steering column. If abrasion or exposure of bare wires is found, repair as necessary. If aftermarket
accessory wiring is improperly connected, advise the vehicle owner. Advise also the repairs of such faults are at customer expense.
12.
Install any components previously removed for access ensuring that no wires are pinched and the components are properly seated. Refer to
appropriate service repair manual as required.
Owner Letter
Mail Date
Serial Number: XXXXXXXXX C 95828
J. Sample
123 Main Street
Anywhere, Prov.
ANA NAN
This notice is sent to you under the requirements of the Motor Vehicle Safety Act of Canada.
Ford Motor Company of Canada, Limited (Ford) is conducting a safety recall of certain 1989-90 Model Year Escort, 1989-91 Model Year Mustang,
1990-91 Model Year Thunderbird and Cougar, 1988-89 Model Year Crown Victoria and Grand Marquis, 1989 Model Year Lincoln Town Car, 1989-91
Model Year Aerostar, and 1990 Model Year Bronco and F-Series light trucks. Our records show you own the vehicle with the serial number shown
above your name and address.
Description:
On some of the affected vehicles, a short circuit could develop in the ignition switch that could lead to overheating, smoke, and possibly fire in the
steering column area of your vehicle. The condition may occur while the vehicle is in use or unattended.
Repairs:
At no charge to you, your Ford or Lincoln-Mercury dealer will replace the ignition switch with a revised design switch. Dealers currently have
instructions and parts ordering information.
The dealer will also check the wiring in the upper steering column area and will inspect for the installation of any aftermarket electrical accessories. If an
improper installation is noted that is not part of this recall, you will be advised to have it corrected.
How Long Will It Take?
The time needed for this service is less than one hour. However, due to service scheduling times, your dealer may need your vehicle for one full working
day.
Call Your Dealer:
