Aerostar AWD V6-183 3.0L (1991)
Water Pump
3. Install water pump on timing cover and hand start 11 attaching bolts. Tighten water pump bolts to following torque:
a. 8 x 1.25 mm to 25 Nm (19 ft lb).
b. 6 x 1.25 mm to 10 Nm (7 ft lb).
4. Install lower radiator hose and heater hose to pump.
5. Install water pump pulley assembly and hand tighten four attaching bolts.
6. Install alternator adjusting arm and brace.
7. Install both accessory drive belts.
8. Torque pulley bolts to 25 Nm (19 ft lb).
9. Install cooling fan.
10. Fill and bleed cooling system with proper coolant mixture.
11. Connect negative battery terminal.
12. Run engine and check for coolant leaks.
