Aerostar AWD V6-183 3.0L (1991)
Compressor Shaft Seal: Service and Repair
Except for manifold hose O-rings and front shaft seal this compressor is not serviceable and must be replaced as an assembly.
Removal
1.
Drain oil from compressor through manifold openings.
2.
Clamp compressor in suitable vise, then remove clutch hub.
3.
Remove shaft seal felt from nose of compressor.
4.
Remove retaining snap ring as follows:
Fig. 25 Snap ring tool placement. FX-15
a. Insert tip of snap ring remover T89P-19623-DH or equivalent into one of snap ring eyes. Fig. 25.
b. Rotate tool to position tip and snap ring eye closest to compressor shaft. Fig. 26.