Aerostar AWD V6-183 3.0L (1991)
Child Restraint: Service and Repair
Child Seat Locking Clip
The locking clip must be used to secure a child seat when your vehicle has a shoulder and lap belt with a sliding tongue. The locking clip is not needed
it the seat belt has only a lap belt. It you do not use a locking clip, injuries could result from the child seat tipping over during normal braking or
turning.
1. Thread the belt webbing through the child seat according to the child seat manufacturers instructions.
2. Buckle seat belt. Pull on shoulder portion of the belt to make the lap portion fit snugly.
3. Slide either corner of locking clip slot closest to the tongue, over both layers of webbing as shown in Illustration "A"
4. Pinch both opposite edges of webbing together and insert them into locking clip slot as shown in Illustration "B".
5. Tighten the lap belt by pulling on the shoulder belt as shown in Illustration "C".
6. Insert both layers of webbing into the other slot of the locking clip in the same manner as step 4. See Illustration "D".
7. Forcibly tilt the child seat from side to side and also tug it forward to see if it is held securely in place. If excessive movement occurs, repeat steps
3 through 7 or properly install the child seat in a different seating position in the vehicle.
