Aerostar AWD V6-245 4.0L (1990)
Ignition Control Module: Service and Repair
Removal
1.
Disconnect battery ground cable.
2.
Disconnect electrical connector from module.
3.
Remove module mounting bolt, then the module. To release module from tear-drop hole in right inner fender apron, slide assembly toward
the front of the vehicle.
Installation
1.
Insert rivet of module into tear-drop mounting hole on fender apron and push into position.
2.
Install retaining screws, then torque screws to 22-31 inch lbs.
3.
Connect electrical connector to the module.
4.
Connect battery ground cable.
