Aspire L4-81 1.3L SOHC (1994)
b. When installing NEW halfshaft attaching nut, apply brakes to prevent hub assembly from turning. Stake nut into groove on halfshaft after
tightening to 116-174 ft lb.
c. Tighten tie rod end to steering knuckle attaching nut to 22-33 ft lb, then install new cotter pin.
NOTE: If holes in attaching nut do not line up with hole in ball stud, tighten nut as required until cotter pin can be installed. Never loosen nut
when installing cotter pin.
