ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Front Door Glass - Binds or Comes Out of Track|Page 4255 > < Front Door Glass - Binds or Comes Out of Track|Page 4253
Page 7
background image

8.

Tighten the REAR regulator attaching nut "A", then the LOWER bolt "B" and then the FRONT nut "C" respectively. Tighten the regulator
attaching nuts to 9-13 N-m (7-9 lb.ft.) and the bolt to 8-11 N-m (6-8 lb.ft.) (Figure 7).

NOTE:

FOLLOW THE TIGHTENING SEQUENCE: REAR NUT "A", LOWER BOLT "B", THEN FRONT NUT "C".

9.

Roll the window to the full down, then full up position and then to the full down position; pay attention to the efforts.

10.

It the window rolls up and down and the efforts are acceptable but higher than normal, lubricate the window runs with Ford Silicone Lubricant
(D7AZ-19553-AA, aerosol, or COAZ-19553-AA, tube).

NOTE:

ONE CAN OF FORD SILICONE LUBRICANT AEROSOL IS ABLE TO ACCOMMODATE APPROXIMATELY 30 APPLICATIONS.

11.

After any adjustment is made, cycle the window and observe the change in roll up efforts.

Parts Block

OTHER APPLICABLE ARTICLES: NONE 
WARRANTY STATUS: Eligible Under The Provisions Of 12 Month/12,000 Mile Basic Warranty Coverage

OPERATION DESCRIPTION

TIME

950402A

Adjust One Front Door

0.3 Hr.

Glass Track

950402B

Adjust Both Front Door

0.6 Hr.

Glass Tracks

950402C

Adjust One Front Door

0.6 Hr.

Glass Track And Adjust Or
Replace Regulator

Front Door Glass - Binds or Comes Out of Track|Page 4255 > < Front Door Glass - Binds or Comes Out of Track|Page 4253