Aspire L4-81 1.3L SOHC (1994)
^
HOLE 1: Elongate the top REAR hole (H1) 1 mm downward by grinding with a file (Figure 5).
^
HOLE 2: Elongate the lower hole (H2) 1.5 mm forward by grinding with a file (Figure 5).
^ HOLE 3: Do not change the top FRONT hole (H3) (Figure 5).
3.
Apply primer to elongated holes.
4.
Install the regulator and tighten the attaching nuts and bolt; hand tighten only.
5.
Install the window glass.
6.
Tighten the window glass-to-regulator attaching bolts. Tighten the FRONT bolt "A", then the REAR bolt "B", to 8-11 N-m (6-8 lb.ft.) (Figure 6).
NOTE:
FOLLOW THE TIGHTENING SEQUENCE:
FRONT BOLT "A", THEN REAR BOLT "B".
NOTE:
CARE MUST BE USED TO AVOID OVER-TORQUING; STRIPPING OF THE PLASTIC MOUNTING TABS MAY OCCUR.
7.
Roll the window to the full up position and then push the glass rearward, by hand, to position the glass fully into the glass run.
