Aspire L4-81 1.3L SOHC (1994)
9.
Roll the window to the full down position, to the full up position and then to the full down position.
10. Tighten the window glass-to-regulator attaching bolts. Tighten the FRONT bolt "A", then the REAR bolt "B", to 8-11 N-m (6-8 lb.ft.) (Figure 6).
NOTE:
FOLLOW THE TIGHTENING SEQUENCE: FRONT BOLT "A", THEN REAR BOLT "B".
NOTE:
CARE MUST BE USED TO AVOID OVER-TORQUING; STRIPPING OF THE PLASTIC MOUNTING TABS MAY OCCUR.
11.
Roll the window to the full up position and then to the full down position; pay attention to the efforts.
12.
If the window rolls up and down and the efforts are higher than normal or unacceptable, adjust the regulator using the following procedure.
NOTE:
VERIFY THE WINDOW RUN IS POSITIONED CORRECTLY AND EFFORTS ARE HIGHER THAN NORMAL.
REGULATOR ADJUSTMENT REPAIR
1.
Remove the glass and regulator from the door.
2.
Elongate the regulator attaching holes as follows:
